F2 - Unheaded PressFit Threaded Inserts
< Back to products

PressFit Threaded Inserts

F2 - Unheaded PressFit Threaded Inserts

The 'Pressfit' range of threaded inserts suits applications where the inserts are pressed-in cold into compression moldings. Different designs cater for all types of applications and materials. No expensive equipment is required to install the threaded inserts, which are, in turn, easy to install. These threaded inserts have high torque performance.

Downloads

P/NOPRODUCT CODETHREADADREC. HOLE SIZEMIN. WALL THICKNESS
01023F2/BM24.13.43.11.6
00236F2/BM2.55.34.23.82.0
00037F2/BM35.34.23.82.0
01411F2/BM3.56.35.04.62.5
00777F2/BM47.45.85.42.5
00012F2/BM58.36.66.22.5
00108F2/BM69.28.27.82.8
00109F2/BM89.29.79.33.8
02265F2/BM109.212.712.35.0

Further Information About This Product

Product advantages of these Fitsco threaded inserts:

  • These threaded inserts are easy to install
  • There is no expensive equipment required to install these threaded inserts
  • High torque performance

Applications:

  • Hole Preparation: Moulded holes are recommended. The hole diameter is measured at the point where the bottom of the threaded insert meets the moulded hole
  • Installation: The threaded insert must be installed using a slow, squeezing action. The threaded inserts must be allowed to rotate as they are installed
  • Wall Thickness: The wall thickness is critical to prevent cracking, and should be no less than half the specified hole diameter
© Fitsco Industries Ltd.
Website by Remote