F4/1 - Unheaded PressFit Threaded Inserts
< Back to products

PressFit Threaded Inserts

F4/1 - Unheaded PressFit Threaded Inserts

The F4/1 PressFit range is a press-in expansion threaded insert which is Ideal for use in hard thermoset compression moldings. The diamond knurl pattern grips with the internal side of the hole providing a pull-out resistance. The threaded inserts are easy to install as no expensive equipment is required during application. The threaded inserts have high torque performance.

Equivalent to:

PSM N41 ; Spirol Series 15 (INS15) ; TR Fastenings Expansion-Sert (TR0003077) threaded inserts

Downloads

THREADABRECOMMENDED HOLE SIZEMINIMUM WALL THICKNESS
M23.93.23.22.4
M2.54.7443.2
M34.7443.2
M3.56.34.74.83.6
M47.95.55.64
M59.46.36.44.8
M612.67.986
M812.69.59.67

Further Information About This Product

Product advantages of these Fitsco threaded inserts:

  • The threaded inserts are easy to install
  • No expensive equipment is required to install these threaded inserts
  • High torque performance

Applications:

  • Hole Preparation: Moulded holes are recommended. The hole diameter is measured at the point where the bottom of the threaded insert meets the moulded hole
  • Installation: The threaded insert must be installed using a slow, squeezing action. The threaded inserts must be allowed to rotate as they are installed
  • Wall Thickness: The wall thickness is critical to prevent cracking, and should be no less than half the specified hole diameter
© Fitsco Industries Ltd.
Website by Remote