< Back to products

HeatFit Inserts

Unheaded Version

The 'Heatfit' range of threaded inserts is suitable for all types of thermoplastic injection mouldings. All inserts can be installed using 'heat staking' or 'ultrasonic' equipment and are available in a range of sizes and studded versions.

Equivalent to:

PSM Sonic-Lok (SL) ; Spirol Series 19 (INS19) ; TR Fastenings Sonic-Sert (TR0003125)

Note: For comparison purposes only

Downloads

Unheaded Heatifit Datasheet

Enquire about this product
More Info

P/NO	PRODUCT CODE	THREAD	A	D	REC. HOLE SIZE	MIN. WALL THICKNESS
00007	F1/B	M2	4	0.55	3.2	2
00043	F1/B	M2.5	5.8	4.6	4	2.3
00655	F1/B	M3	5.8	4.6	4	2.3
00050	F1/B	M3.5	7.2	6.4	4.8	2.5
00006	F1/B	M4	8.2	6.3	5.6	2.5
00008	F1/B	M5	9.5	7	6.4	2.7
01050	F1/B	M6	12.7	8.6	8	3
00030	F1/B	M8	12.7	10.2	9.6	3.5
01764	F1/B	M10	12.7	12.3	11.9	6

Further Information About This Product

Product Advantages

The use of heat minimises the stress introduced into the boss
Heat installation provides high torque and pull-out performance
Easy to install using heat staking or ultrasonics
Knurls facing opposite directions provide greater resistance in the plastic.

Applications:

Hole Preparation: Moulded holes are recommended. The hole diameter is measured at the point where the bottom of the insert meets the moulded hole.
Installation: The insert is installed by either pre-heating the insert or the use of ultrasonics.
Wall Thickness: An appropriate guide is that the wall thickness should ideally not be less than 1/2 the hole diameter

Downloads

Unheaded Heatifit Datasheet

HeatFit Inserts

Unheaded Version

Downloads

Further Information About This Product

Product Advantages

Applications:

Downloads

You may also be interested in

HeatFit Inserts